Leak Detection in Hudson Bend, TX
Hudson Bend has some of the most mineral-rich well water in the Austin metro — calcium hardness in Apache Shores and Cardinal Hills routinely tests 400 to 600-plus ppm — and that matters more for leak detection than most people realize. Years of that water running through plumbing scales the inside of lines and corrodes fittings from the inside out, so the leaks we find in the 78734 corridor often start at threaded connections, heater unions, and old equipment-pad joints rather than in the shell. The Pool Police confirms real loss with a bucket test first, since the hilly, gravel-road terrain also kicks dust and sediment into pools and muddies the picture. Then we pressure-test the supply and return lines, dye-test the shell and fittings, and put electronic listening gear on lines buried under rural hillside lots. We pay close attention to the equipment pad, because the manual timers and older controls common out here usually sit beside the same aging, scale-corroded plumbing. Keith Mallette has managed Hudson Bend well-water pools for over two decades and has found hundreds of leaks — you get a written report with the exact source and your repair options.
What We Do
Why The Pool Police?
Local Conditions We Account For in Hudson Bend
Every leak detection visit in Hudson Bend is calibrated to the conditions that make pools here different — not a generic checklist:
Neighborhoods We Serve in Hudson Bend
Frequently Asked Questions
How does Hudson Bend well water affect my pool?
Hudson Bend well water typically tests very high in calcium hardness (400–600+ ppm) and total alkalinity. Without careful management, this leads to heavy scale on tile lines, inside heaters, and on salt cells, plus cloudy water and pH that won't stay down. We use a combination of sequestrants, acid additions, and adjusted chemical targets specifically for well water pools.
Do you service pools off the main roads in Hudson Bend?
Yes. We service pools throughout the Hudson Bend area including Apache Shores, Cardinal Hills, and the surrounding rural properties. We're accustomed to gravel driveways and gated properties — just let us know about access details.
How do I know if my pool is leaking or just evaporating?
In Austin's summer heat, pools can lose up to a quarter-inch per day to evaporation alone. The simplest test is the bucket method: fill a bucket to match your pool level, set it on the step, and compare levels after 24 hours. If the pool drops more than the bucket, you likely have a leak.
Can you find leaks without digging up my yard?
Yes. We use pressure testing, dye injection, and electronic listening to pinpoint leaks before any excavation. In most cases we can identify the exact location without touching your deck or landscaping. Digging only happens at the confirmed leak point.
How long does a leak detection visit take?
A typical leak search takes two to four hours, depending on pool size and plumbing complexity. We aim to identify the source in a single visit so you can make a repair decision right away.
Ready to Get Started?
No contracts, no hidden fees. Just reliable, professional pool service from a family that's been doing it for 25+ years.
(512) 300-4136