Equipment Repair in Cedar Park, TX
Cedar Park's pool equipment fails earlier than it should, and the reason is usually what came with the house. Across the newer subdivisions in the 78613 and 78681 zip codes — Twin Creeks, Cypress Canyon, and the rest — builders installed minimum-spec pumps, single-speed motors, and thin cartridge filters sized to hit a price point, not to last. The Pool Police sees these builder-grade systems give out years before a properly specced setup would, and we repair them the smart way. We rebuild what's worth rebuilding, and when an undersized single-speed motor finally dies, we'll point you to a variable-speed pump that actually fits your pool and cuts the energy bill that builder-grade unit was quietly running up. The alkaline municipal water here also drives pH up, which is hard on heater components and salt cells over time. Keith Mallette has repaired Cedar Park equipment since 2000 — fix-first, no pushing replacements you don't need, and an honest read on whether your builder setup is worth keeping.
What We Do
Why The Pool Police?
Local Conditions We Account For in Cedar Park
Every equipment repair visit in Cedar Park is calibrated to the conditions that make pools here different — not a generic checklist:
Neighborhoods We Serve in Cedar Park
Frequently Asked Questions
Why is my Cedar Park pool's pH always high?
Cedar Park's municipal water supply runs naturally high in alkalinity, which constantly pushes pH upward. Left unchecked, high pH reduces chlorine effectiveness and causes cloudy water. We add muriatic acid in controlled doses each visit to keep pH in the ideal 7.4 to 7.6 range.
My pool was built with the house — is the equipment good enough?
Often, no. Many Cedar Park builders install the minimum-spec equipment to hit a price point. Undersized pumps, single-speed motors, and thin cartridge filters are common. We'll evaluate your setup and let you know if anything should be upgraded — especially if you're spending more on energy than you need to.
My pool pump is making a loud screeching noise — what should I do?
A screeching pump usually means the bearings are failing. Turn the pump off to prevent further damage and call us. Bearing replacement is far less expensive than a new motor, but only if caught early before the shaft or windings are affected.
How long do pool pumps typically last in Austin?
A standard single-speed pump motor lasts around 8 to 12 years in our climate. Variable-speed pumps tend to last longer because they run at lower RPMs. Proper chemical balance and regular service extend the life of any pump.
Should I repair my old equipment or replace it?
It depends on the age of the unit and the cost of the repair. As a rule of thumb, if the repair exceeds 50% of replacement cost and the unit is past its expected lifespan, replacement usually makes more sense — especially with newer energy-efficient options available.
Related Services & Locations
Ready to Get Started?
No contracts, no hidden fees. Just reliable, professional pool service from a family that's been doing it for 25+ years.
(512) 300-4136