Pool Pump Repair Austin | The Pool Police
Pool Pump Repair Austin | The Pool Police
Austin's Pool Pump Stopped Working? Here's What We Do.
When your pool pump fails, your water stops circulating—and within 24 to 48 hours, algae and bacteria start taking over. The Pool Police provides pool pump repair in Austin and the surrounding Hill Country area, including Lakeway, Bee Cave, and Steiner Ranch. We diagnose the problem the same day you call, source parts fast, and get your pump running again without making you wait a week. Whether your pump is humming but not moving water, tripping the breaker, or leaking around the housing, we've seen it and fixed it.
A dead pool pump isn't just an inconvenience—it's a chemistry crisis. Stagnant water can turn green in under 48 hours in Austin's summer heat. Call for a same-day diagnosis before the problem doubles in cost.
What Our Pool Pump Repair Service Includes
We don't just swap parts and leave. Every pool pump repair visit covers a full inspection so you're not calling us back next week for the same issue.
Every service call includes:- Full diagnostic test to identify the root cause (motor, capacitor, impeller, seals, or wiring)
- Pressure and flow rate checks before and after the repair
- Inspection of the pump basket, lid O-ring, and housing for cracks or wear
- Check of the pump's electrical connections and timer settings
- Test run after repair to confirm proper operation
- Written summary of what was found and what was fixed
- Recommendations for any related issues spotted during the visit (filter condition, equipment age, etc.)
---
Common Pool Pump Problems We Repair
Motor Won't Start
A pool pump that won't turn on is usually a failed capacitor, a burned-out motor winding, or a tripped thermal overload. Capacitor replacements are quick and affordable—often under $75 in parts. A full motor replacement costs more, but we'll always tell you upfront whether repair or replacement makes more financial sense given your pump's age.Pump Is Running But Water Isn't Moving
This usually points to a clogged or damaged impeller, air leak on the suction side, or a closed valve. We disassemble the pump housing, clear the blockage or replace the impeller, and seal any air leaks causing the pump to lose prime.Loud Grinding or Screeching Noise
Grinding means the bearings inside the motor are worn out. Left alone, a grinding pump will fail completely within days to weeks. We can often replace just the motor end rather than the whole pump assembly.Pump Is Leaking Water
Leaks almost always come from a failed shaft seal or a cracked pump housing. Shaft seals are a standard repair. A cracked volute (the plastic pump body) usually means it's time for a new pump—we'll give you an honest assessment.Pump Keeps Tripping the Breaker
This signals either a motor drawing too much current (often from worn bearings or a failing capacitor) or an electrical issue on the circuit itself. We test both before assuming the worst.Never keep resetting a breaker that a pool pump keeps tripping. Repeatedly forcing a failing motor to restart can fry the motor windings completely, turning a $150 repair into a $600 pump replacement.
How the Repair Process Works
---
What Pool Pump Repair Costs in Austin
Pricing depends on the specific problem, the pump brand and model, and whether you need parts sourced locally or ordered. Here's a general breakdown to set expectations:
| Repair Type | Typical Cost Range |
|---|---|
| Diagnostic visit fee | $75 – $100 (applied to repair) |
| Capacitor replacement | $100 – $175 |
| Shaft seal replacement | $150 – $275 |
| Impeller cleaning or replacement | $125 – $250 |
| Motor replacement (labor + part) | $350 – $600 |
| Full pump replacement (labor + pump) | $550 – $1,200+ |
If your single-speed pump is more than 8 to 10 years old and needs a motor replacement, it may be worth upgrading to a variable-speed model instead. Variable-speed pumps can cut energy costs by 50 to 70% and often pay for themselves within 2 to 3 years in Austin's year-round swimming season.
Why Austin Pool Owners Choose The Pool Police
We're Local to the Hill Country
We're based in Lakeway, which means we're not driving 45 minutes from North Austin to reach you in Bee Cave or Steiner Ranch. Shorter drive times mean faster response when your pump goes down on a hot Saturday morning.Honest Diagnostics, No Upselling
We'll tell you when a $150 repair makes sense and when it doesn't. If your pump is 12 years old and needs a $500 motor, we'll explain why a new pump might be the smarter buy. We'd rather give you the honest answer than sell you a repair that fails again in six months.We Do More Than Just Pumps
Because we offer full pool equipment repair in Austin, we can spot related problems during a pump service call—a dirty filter that's straining the pump, a chemical imbalance caused by poor circulation, or a slow leak in the plumbing. One visit often covers more than one problem.We Know Austin's Conditions
Austin summers are brutal on pool equipment. Pumps running 8 to 12 hours a day in 100-degree heat wear out faster than the manufacturer's specs suggest. We've repaired hundreds of pumps across the Austin metro and know exactly which failure modes are most common here. If you're also due for a pool filter cleaning, we can often handle both in the same visit.---
Frequently Asked Questions
How do I know if my pool pump needs repair or replacement? Age and repair cost are the two main factors. If the pump is under 7 years old and the repair is under 50% of a new pump's cost, repair usually makes sense. If it's older than 10 years or needs a motor replacement, we'll run you through the numbers so you can make an informed call. How long does a pool pump repair take? Most repairs—capacitor swaps, seal replacements, impeller fixes—are done in 1 to 2 hours on-site. If we need to order a part, the repair is typically completed within 1 to 3 business days. Can I run my pool without a working pump? Not for more than a day or two. Without circulation, your pool water will stagnate, chlorine will dissipate, and algae will bloom fast—especially in Austin's summer heat. The cost to fix green water often exceeds the cost of the pump repair itself. Do you repair all pool pump brands? We work on all major brands including Pentair, Hayward, Jandy, Sta-Rite, and IntelliFlo. For less common brands, we may need to source parts, which can add a day or two to the timeline. My pump is making a loud humming noise but not starting. Is that fixable? Almost always yes. A pump that hums but won't spin usually has a failed starting capacitor—one of the least expensive and quickest repairs we do. Don't let it sit, though. Continued attempts to start a pump with a bad capacitor can burn out the motor. Do you offer any ongoing maintenance after the repair? Yes. Many customers add our weekly pool cleaning service after a repair so they have a professional set of eyes on their equipment every week. Catching small issues early is always cheaper than emergency repairs.---
Ready to Get Your Pool Pump Running Again?
Don't let a broken pump turn your pool into a green mess. The Pool Police serves Austin, Lakeway, Bee Cave, Steiner Ranch, and the surrounding Hill Country area. Call us today or book online and we'll get a technician out to diagnose your pump—usually same day or next day. We'll give you a straight answer, a fair price, and a pump that actually works when we leave.
Call The Pool Police or book your pool pump repair online. We'll take it from here.Frequently Asked Questions
How do I know if my pool pump needs repair or replacement?
Age and repair cost are the two main factors. If the pump is under 7 years old and the repair costs less than 50% of a new pump, repair usually makes sense. If it's over 10 years old or needs a motor replacement, we'll walk you through the numbers so you can decide what's right for your situation.
How long does a pool pump repair take?
Most repairs—capacitor swaps, seal replacements, impeller fixes—are completed in 1 to 2 hours on-site. If we need to order a part, the repair is typically finished within 1 to 3 business days.
Can I run my pool without a working pump?
Not for more than a day or two. Without circulation, your water will stagnate, chlorine will dissipate, and algae will bloom fast—especially in Austin's heat. The cost to fix green water often exceeds the pump repair cost itself.
Do you repair all pool pump brands?
We work on all major brands including Pentair, Hayward, Jandy, Sta-Rite, and IntelliFlo. For less common brands, parts may need to be ordered, which can add a day or two to the turnaround.
My pump hums but won't start. Is that fixable?
Almost always yes. A humming pump that won't spin usually has a failed starting capacitor—one of the quickest and least expensive fixes we do. Don't keep trying to force it to start, though, as that can burn out the motor and turn a small repair into a big one.
Do you offer maintenance after the repair?
Yes. Many customers add our weekly pool cleaning service after a repair so a professional is checking their equipment every week. Catching small issues early is always cheaper than emergency repairs.